Which command is used to configure an IPv6 directly attached static route?

Which command is used to configure an IPv6 directly attached static route?

• A. ipv6 route destination/prefix-length exit-interface
• B. ipv6 route destination/prefix-length next-hop
• C. ipv6 route exit-interface destination/prefix-length
• D. ipv6 route next-hop destination/prefix-length

Answer: (A)

The command to configure an IPv6 directly attached static route is structured as "ipv6 route destination/prefix-length exit-interface." This format indicates that you are specifying the destination network and its prefix length, which identifies the range of IP addresses that will be routed. The exit interface part specifies the interface that traffic should be sent through to reach this destination. When configuring static routes, particularly for directly attached networks, it is essential to define both the destination and the interface through which to send packets. By using this command, you're informing the router how to reach the specific network directly attached to one of its interfaces without needing to specify an intermediate next-hop router, as would typically be required in routes for non-directly attached networks. This command utilizes a straightforward format, reflecting the way IPv6 routes are structured, reinforcing the understanding that when directing traffic to a directly connected network, using the interface is often the most efficient approach. It clarifies the routing decision process, ensuring that the appropriate exit point is selected for outgoing packets destined for that IPv6 network.

The command to configure an IPv6 directly attached static route is structured as "ipv6 route destination/prefix-length exit-interface." This format indicates that you are specifying the destination network and its prefix length, which identifies the range of IP addresses that will be routed. The exit interface part specifies the interface that traffic should be sent through to reach this destination.

When configuring static routes, particularly for directly attached networks, it is essential to define both the destination and the interface through which to send packets. By using this command, you're informing the router how to reach the specific network directly attached to one of its interfaces without needing to specify an intermediate next-hop router, as would typically be required in routes for non-directly attached networks.

This command utilizes a straightforward format, reflecting the way IPv6 routes are structured, reinforcing the understanding that when directing traffic to a directly connected network, using the interface is often the most efficient approach. It clarifies the routing decision process, ensuring that the appropriate exit point is selected for outgoing packets destined for that IPv6 network.